[OpenSPIM] Plugin Power Control

[Anthony, Neil]

Hi all,

Has anybody got any experience with the power control slider not working when connected to a Stradus laser over a COM port?  I have made a short unlisted YouTube to show what's happening and save me a few words here:
https://www.youtube.com/watch?v=2JEiMHxS69w

Key points:

-          I cannot control the power of the active shutter using the power slider - it jumps back to zero

-          When changing through the device controller (which works as it should on the laser itself) it shows what looks like a multiplication factor gone wrong somewhere on the slider.

-          At certain values the slider value jumps back and forth, which is strange

-          It only works for one of the lasers.

Any thoughts would be much appreciated.

Thanks
Neil



________________________________

This e-mail message (including any attachments) is for the sole use of
the intended recipient(s) and may contain confidential and privileged
information. If the reader of this message is not the intended
recipient, you are hereby notified that any dissemination, distribution
or copying of this message (including any attachments) is strictly
prohibited.

If you have received this message in error, please contact
the sender by reply e-mail message and destroy all copies of the
original message (including attachments).
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://openspim.org/pipermail/openspim/attachments/20151218/f1752849/attachment-0002.html>