[OpenSPIM] About the calibration of the lightsheet

[edgar.escobar.nieto at ipt.fraunhofer.de]

 Hi dear All,

I would like to know how you could cut the ruling slides. I don't know if it is possible tu cut a thin part of glass using
a conventional glass cutter. 

Kind regards,
Edgar Escobar Nieto
 _________________________________________________________________________

Fraunhofer-Institut für Produktionstechnologie IPT 
Edgar Escobar Nieto  
 

 
 
Steinbachstraße 17 
52074 Aachen 

edgar.escobar.nieto at ipt.fraunhofer.de 
http://www.ipt.fraunhofer.de
_________________________________________________________________________
 
 
 


-----Weitergeleitet von Edgar Escobar Nieto/Fraunhofer IPT am 06.08.2013 17:01 -----
An: openspim at openspim.org
Von: Edgar Escobar Nieto/Fraunhofer IPT
Datum: 05.08.2013 11:55
Betreff: About the calibration of the lightsheet

 
 _________________________________________________________________________

Fraunhofer-Institut für Produktionstechnologie IPT 
Edgar Escobar Nieto  
 

 
 
Steinbachstraße 17 
52074 Aachen 

edgar.escobar.nieto at ipt.fraunhofer.de 
http://www.ipt.fraunhofer.de
_________________________________________________________________________
 
 
 


-----Weitergeleitet von Edgar Escobar Nieto/Fraunhofer IPT am 05.08.2013 11:54 -----
An: openspim at openspim.org
Von: Edgar Escobar Nieto/Fraunhofer IPT
Datum: 31.07.2013 15:02
Betreff: (Unbenannt)

 Hi dear all,

I reached to the point where I need to calibrate the light-sheet. And I was wondering
what is the optical density of the ND filter recommended to perform the calibration.

I would like to know also what is the Frequency (lp/mm) recommended for the Opal Glass Ronchi Ruling Slides.
I think that high a frequency would be better, but there must be a limit.

Only to be sure, what I understood is that these Ruling Slides have already a reflective surface, so there is no
need to glue a mirror to the ruling slides.

Thank you in advance for your comments.

Kind regards,
Edgar Escobar Nieto
 _________________________________________________________________________

Fraunhofer-Institut für Produktionstechnologie IPT 
Edgar Escobar Nieto  
 

 
 
Steinbachstraße 17 
52074 Aachen 

edgar.escobar.nieto at ipt.fraunhofer.de 
http://www.ipt.fraunhofer.de
_________________________________________________________________________
 
 
 
 
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://openspim.org/pipermail/openspim/attachments/20130806/5dba57fd/attachment-0002.html>