[OpenSPIM] Picard Z stage problem

[Michael Redd]

Hi Johannes,
As Mark pointed out back in June, the problem with the z motor can be
reproduced without any Picard hardware connected to the computer, so it
seems unlikely that it is a serial number problem. However, if it is a
serial number problem, I cannot figure out how to change the range of
serial numbers used by the device adapter by editing the properties? Where
can I find these properties?

Thanks
mike

On 9/25/14 8:34 AM, "Johannes Schindelin" <Johannes.Schindelin at gmx.de>
wrote:

>Sorry for the re-send. I replied to the maintainer (i.e. myself). Please
>note the correct email address of the OpenSPIM mailing list:
>openspim at openspim.org.
>
>On Thu, 25 Sep 2014, Johannes Schindelin wrote:
>
>> Hi Michael,
>> 
>> On Wed, 24 Sep 2014, Michael Redd wrote:
>> 
>> > 2014-09-24T09:58:45.921875 tid3644 [IFO,dev:Picard XY Stage] Found 0
>> > motors and 1 twisters.
>> 
>> It seems that the device adapter does not find the motors. If I recall
>> correctly, they all have serial numbers and the device adapter tries to
>> find them, but it can fail quite easily when the serial numbers are
>> outside of the expected range. But I seem to recall that you can change
>> the serial numbers used by the device adapters by editing the properties
>> in the hardware configuration wizard. Could you give that a try?
>> 
>> Ciao,
>> Johannes
>> 
>>